The Pilot-RC Matrix is an innovative approach to a new sport jet/ 3Djet. Great capabilities had to be combined between sport jet and unbeatable 3D performance. everything aerodynamic we tested and learned from Predator and develop together with one of the best pilot in the world for Matrix performance so we can say this is best ever sport jet with ultimate flying characteristics for precise aerobatics and 3D aerobatics at the same time.

SPECIFICATIONS:

Model: Matrix 2.2m

Wingspan: 78.7in (2m)

Length: 87.6in (2.225m)

Weight: 21.9lbs (9.94kg) with 14kg turbine

FEATURES:

Extremely lightweight full composite construction especially designed for outstanding sport flight with 3D performance

Painted outside the mold so no seam lines

Ultra light weight landing gear

Specially designed easy access to turbine for speedy installation

Field setup can be done in seconds, thanks to the quick releases on the wings without the need for any tools

The single elevator clamp from the top, the clamp only a few turns to tighten/loosen the bolt then you can install/remove the stabiliser

Removable wing and elevator for easy transport

The equipment installation board make the electronic items with very clear installation. Most of the wire can be hidened

Pre-installed tube for the stab/rudder extension wire, easy to install

Optional with vector tail pipe for 3D flight

INCLUDED HARDWARE:

Complete air frame (including carbon wing-tubes and preinstalled and painted fiberglass control horns)

Servo extension leads

Normal tail pipe (Optional Vector thrust pipe)

3.800ml fuel tank (Optional upgrade to fuel bag)

250ml UAT tank

Pre-prepared pushrods with ball links

Servo connector brackets

REQUIRED HARDWARE (NOT SUPPLIED):

Turbine Size:

100-140N for normal sport flying

160-180N for 3D vector flight – Avoid high speed high G flying

Servos: Total x10 (x3 standard size + x7 medium size)

x3 standard size high torque

x2 for flaps (minimum 40kg)

x1 for rudder (minimum 40kg)

x7 medium size servo (size: 35x15x30mm)

x2 for ailerons (minimum 16kg)

x2 for elevators (minimum 16kg)

x1 for vector elevator (minimum 16kg), this is option

x1 for vector rudder (minimum 16kg), this is option

x1 for steering (minimum 10kg)

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.

RECOMMENDED HARDWARE:

Servos: MacGregor MGB8555HV 54.7Kg/0.12s High Voltage Brushless Servo for Flaps and Rudder

Servos: Pilot-RC PW-16AH 16kg.cm/0.057s High Torque Brushless Servo (Includes 1.2in Aluminium Arms) for Aileron, Elevator, Steering, Vector

Servo arms: 10 x Pilot-RC 1.2in Aluminium Arms (with Vector pipe) - PIL556 | 1 x Pilot-RC 0.8in Aluminium Arm for steering - PIL741 & 9 x Pilot-RC 1.2in Aluminium Arms (without Vector pipe) - PIL556